香港志强牌万能磨刀机,具有磨削精度高、安装方便、造型美观、结构新颖,各转动部位灵活，噪音低、振动小，刀架部分带轴承，耐用、耐磨、操作方便等特点，专门设计用于刃磨刻模铣床、刻字机、刻线机、电脑雕刻机.打标机等各种直径、形状、角度的雕刻尖刀、端铣刀、刻刀和按刻模比例相应的靠模销。因此它是机械加工及雕刻行业刀具刃磨的必备的配套设备。

Omnipotent knife sharping of strong Hong Kong aspiration plate machine, have grinding accuracy is high , installation is convenient , attractive appearance , structure are new and original , every turns location nimbly , noise is low , vibration is small , the tool carrier part brings axle bearing along, characteristics such as durable , able to endure , handling to go to the lavatory , machine , dividing machine , computer sculpturing machine specially, designing that the mill carves the model milling machine being used for edge , carving characters on a seal. Since bid machine wAIts for the various diameter , form , angle, carve the sharp knife , end milling cutter , graver and report back after according to carving corresponding model proportion explorator. It is machine work and the corollary equipment carving must prepare for that the industry cutter edge grinds therefore. 

标准配置：

注：可选购以下磨刀机配件规格.

⒈磨刀机嗦咀(夹头)规格：

公制—Φ3、Φ4、Φ5、Φ6、Φ8、Φ10、Φ12、Φ14、Φ16mm；

英制—1/8″、3/16″、1/4″、5/16″、3/8″、1/2″、5/8″、3/4″、7/8″、1-1-1/8″。

⒉砂轮种类和粒度：

白玉钢砂轮： 80#、120#；

金钢石砂轮：100#、150#、320#、600#；

树脂砂轮：150#、180#、320#、400#、800#、1000#、1200#。

⒊预先订货说明夹头公制或英制规格和数量，其中Φ3至Φ12mm（或1/8″至1/2″）为通孔，Φ16mm（或5/8″）夹持长度为50mm。